W04FXO – Quick Installation Guide

The steps below help you to connect and configure the FXO gateway. Thanks to W04FXO gateway, you can connect analog lines to your IP PBX, but not only; you can enhance your legacy PBX with Unified Communications capabilities.

Read the white paper:
http://www.wildix.com/wp-content/uploads/downloads/2015/07/fxo-whitepaper.pdf

Updated: July 2015

Note: W04FXO are supported starting with WMS version 2.0.16043.9

Quick Overview
Connection to power supply (old models without PoE)
Connection to Ethernet
Connection to the line
Provisioning of the gateway
Edit the trunk parameters
Reset of the gateway

Quick Overview

Rear panel

  • Reset switch
  • Power supply
    • Input: AC100V~240V, 50/60Hz
    • Output: DC 12V, 1.5A
  • Network ports
    • 2 Ethernet ports RJ-45, 10/100 base-T
      • 1 WAN port
      • 1 LAN port configured in Bridge
  • FXO ports
    • 4 analog ports RJ-11

Front panel

  • 1 Power LED indicating that the gateway is powered
  • 1 Status LED indicating that the gateway functions
  • 1 Proxy LED indicating that the gateway is registered on SIP proxy
  • 1 LAN LED indicating that the gateway is connected to the network via this port
  • 1 WAN LED indicating that the gateway is connected to the network via this port
  • 4 LEDs Line1…Line4 indicating that the activated analog ports are connected:
    • blinking LED indicates that the line is activated but not connected
    • LED is ON indicates that the line is busy in the conversation
    • LED is OFF indicates that the line is connected and free

Connection to power supply (old models without PoE)

Connect the gateway using the power supply and the cable provided with the gateway, as it is shown on the picture.

Connection to Ethernet

The gateway has one LAN port configured in Bridge mode and one WAN port set up as a DHCP Client. Connect one of two ports to the same network as the PBX or an external DHCP server (for instance, its router) as shown on the picture.

As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the gateway configuration.

  • In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
  • In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned to the gateway

Connection to the line

W04FXO gateways have 4 ports on the rear part of the devices, marked as Line1, Line2, Line3, Line4. Connect the needed ports to the analog lines.

Provisioning of the gateway

Follow our online guide to provision the FXO gateway.

For remote/unreachable media gateways behind NAT/Firewall, follow our online guide to remote provisioning.

Edit the trunk parameters

Follow our online guide to correctly set up the trunk parameters of the FXO gateway.

Reset of the gateway

In case you need to reconfigure the gateway, you should perform a reset procedure, as shown on the picture. The switch marked as “Reset/Default” is situated on the rear panel of the gateway.

  • use the paper clip or the object of the similar shape to press the button;
  • keep the button pressed for 5 seconds;
  • when the LED Status turns on, the reset of the gateway is complete.
    1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...